KnE Materials Science

ISSN: 2519-1438

The latest conference proceedings on physical materials, energy materials, electrical materials.

Prospects of Replacing Natural Sand with Crushed Rock Fines in the Composition of Fine-Grained Concrete

Published date: Dec 31 2020

Journal Title: KnE Materials Science

Issue title: IV Congress “Fundamental Research and Applied Developing of Recycling and Utilization Processes of Technogenic Formations” Volume 2020

Pages: 499–504

DOI: 10.18502/kms.v6i1.8132

Authors:

I.K. Domanskaya - i.k.domanskaya@urfu.ru

T.S. Laskina

Abstract:

The expediency of replacing natural quartz Sands, whose reserves are gradually exhausted, by rock screenings as part of fine-grained concretes is shown. In particular, the characteristics of granite and quartzite crushing screenings in comparison with quartz river sand are presented, as well as the results of studying the strength and abrasion of the fine-grained concrete obtained. To exclude the effect of the grain composition on the properties of concrete, aggregate samples were pre-fractionated, and the conditions for producing concrete (cement consumption, water-cement ratio, concrete mix mobility) were the same. It was found that quartz sand having rounded grains with a relatively smooth surface promotes the formation of dense particle packing and increases the strength of fine-grained concrete by 9-14%, but at the same time reduces the abrasion of similar standard samples by 20-30% compared to screenings crushing of granite and quartzite. The maximum abrasion resistance showed concrete containing quartzite screening. Quartzite – metamorphic (metasomatic) dense rock crushing which produces angular particles with a rough surface. The absence of dense packaging reduces the compressive strength of concrete samples containing quartzite aggregate compared to quartz sand. At abrasion of similar samples in a thin layer the resistance to sliding of filler particles one relative to another increases. Therefore, when choosing crushed rock fines instead of natural quartz Sands, it is important to consider the purpose of the designed fine-grained concrete.

Keywords: crushing screenings, quartz sand, granite, quartzite, fine-grained concrete, strength, abrasion

References:

[1] Latypov, D. V. (2016). State, Problems and Prospects of Development of Mining Enterprises of Construction Materials Industry. Mining information and analytical Bulletin, issue 12, pp. 51–60.

[2] Dolotkazin, A. A. (2006). Screenings are Presented: The Problem to be Solved. Building materials, issue 7, pp. 28-29.

[3] Butkevich, G. R. (2013). Development of Non-Metallic Building Materials Industry in Russia and the USA. Past and Prospects. Building materials, issue 10, pp. 4–9.

[4] Medina, G., et al. (2017). Granite Quarry Waste as a Future Eco-Efficient Supplementary Cementitious Material: Scientific and Technical Considerations. Journal of Cleaner Production, vol. 148, pp. 467-476.

[5] Singh, S., et al. (2017). Experimental Investigation of Sustainable Concrete made with Granite Industry By-Product. Journal of Materials in Civil Engineering, vol. 29, р. 04017017. doi: 10.1061/(ASCE) MT.1943- 5533.0001862.

[6] Mashaly, A. O., Shalaby, B. N. and Rashwan, M. A. (2018). Performance of Mortar and Concrete Incorporating Granite Sludge as Cement Replacement. Construction and Building Materials, vol. 169, pp. 800–818.

[7] Makeev, A. I. and Chernyshov, E. M. (2018). Granite Crushing Screenings as a Component Factor of Concrete Structure Formation. Part I. Problem Statement. Identification of Dropouts. Building materials, issue 4, pp. 56–60.

[8] Rana, A., et al. (2016). Recycling of Dimensional Stone Waste in Concrete: A Review. Journal of Cleaner Production, vol. 135, pp. 312–331.

[9] Lazutkin, A. V., Eirikh, V. I. and Zhukov, V. P. (2003). The Use of Crushing Screenings is an Important Factor in the Economic Growth of Non-Metallic Industry Enterprises, issue 11, pp. 6–8.

[10] Lesovik, R. V. (2015). On the Choice of Technogenic Sands for Composite Binders and Fine-Grained Concretes. Concrete Technology, issue 1-2, pp. 60–63.

[11] Dvorkin, L. I. and Sitkowski, V. V. (2017). High-Strength Fine-Grained Concrete using Granite Screenings. Concrete Technology, issue 5–6 (130-131), pp. 21-25.

[12] Domanskaya, I. K. (2010, March). Optimization of Fractional Composition of Fine Aggregate. Presented at The Russian Сonference Construction materials science today: actual problems and prospects of development, Chelyabinsk, Russian Federation. Chelyabinsk: Printline, pp. 33–34.

Download
HTML
Cite
Share
statistics

356 Abstract Views

407 PDF Downloads