Published date: Mar 25 2021

Journal Title: KnE Life Sciences

Issue title: The 2nd International Scientific Meeting on Public Health and Sports (ISMoPHS 2020)

Pages: 368–379

DOI: 10.18502/kls.v0i0.8896

Ratih Anggraeniratih.anggraeni.1906126@students.um.ac.idDepartment of Public Health, Faculty of Sport Science, Universitas Negeri Malang, Malang, Indonesia

Ramadani .Department of Mechanical Engineering, Faculty of Engineering, Universitas Negeri Malang, Malang, Indonesia

Muhammad Najib MauludiDepartment of Mechanical Engineering, Faculty of Engineering, Universitas Negeri Malang, Malang, Indonesia

Affan Al-MaududiDepartment of Public Health, Faculty of Sport Science, Universitas Negeri Malang, Malang, Indonesia

Muhammad Rifqi SaifullahDepartment of Public Health, Faculty of Sport Science, Universitas Negeri Malang, Malang, Indonesia

Muhammad Al-IrsyadDepartment of Public Health, Faculty of Sport Science, Universitas Negeri Malang, Malang, Indonesia

Waste is a wordlwide problem including in Indonesia. The increasing amount of waste is caused by the increasing human population. Proper waste management must be applied to avoid detrimental health and environmental consequences. One way to manage waste is to design a device that could convert waste into electrical energy. This research aimed to provide a solution so that the volume of waste in Indonesia can be reduced and used as renewable energy. The methods used in this research were (1) identifying previous research on waste incineration and (2) designing a waste incinerator as appropriate technology and equipped with a system of utilizing the generated heat into electrical energy. The result of this research is the design of a device that can produce electricity from smoke and thereby reduce air pollution. Smoke from waste burning in a furnace was first filtered using a carbon cloth material to reduce air pollution. The heat from combustion was used to boil the water and change it into fumes above 100ºC. The steam produced had potential energy which was converted into kinetic energy through a turbine that can move the shaft to produce mechanical energy. Mechanical energy was then used to rotate the generator shaft that generated electric current and was then used to charge the battery. The battery power was then distributed for regualr use using a power converter.

Keywords: combustion, design, electricity, environment, health, waste

[1] Widowati, E. (2019, November). Komposisi Sampah di Indonesia Didominasi Sampah Organik. Retrieved from https://databoks.katadata.co.id.

[2] BPS. (2019). Statistik Indonesia 2019. Jakarta: Badan Pusat Statistik.

[3] Hidup, D. L. (2019). Penanganan dan Pengendalian Sampah Regional di Jawa Timur. Retrieved from https://dlh.jatimprov.go.id

[4] Bank Sampah Malang. (2018). Emas Hitam Dibalik Tumpukan Sampah. Malang: BSM.

[5] Rhohman, F. and Ilham, M. M. (2019). Analisa dan evaluasi rancang bangun insinerator sederhana dalam mengelola sampah rumah tangga. Jurnal Mesin Nusantara, issue 2, pp. 52–60.

[6] Permana, A. G. and Iqbal, M. (2019). Mesin Pengolahan Sampah Portabel Multiguna Dengan Teknik Termocontrol Dan Termocople. SEBATIK 1410-3737, vol. 23, issue 2, pp. 423–30.

[7] Muiz, A., et al. (2017). Perancangan Pembangkit Listrik Tenaga Sampah Organik Zero Waste di Kabupaten Tegal (Studi Kasus di TPA Penujah Kanupaten Tegal). Jurnal Teknik Mesin, Vol. 6, issue 4, pp. 282–289.

[8] Susastrio, H., et al. (2020). Kajian Incinerator Sebagai Salah Satu Metode Gasifikasi Dalam Upaya Untuk Mengurangi Limbah Sampah Perkotaan. Jurnal Energi Baru dan Terbarukan, vol. 1, issue 1, pp. 26–31, https://doi.org/10.14710/jebt.2020.8135.

[9] Pribadi, A. (2018). Krakatau Steel Bakal Pasok Material Drum Sheet Aspal Pertamina. Retrieved from https://www.wartaekonomi.co.id/read169465/krakatau-steel-bakal-pasok-material-drum-sheetaspal-pertamina.

[10] Sasongko, D. (2016, Februari 27). Lima mahasiswa Universitas Brawijaya Malang menemukan sebuah alat yang berfungsi sebagai penyaring udara kotor. Alat itu diberi nama Automatic Sedot Asap Polusi (ASAP). Retrieved from https://m.merdeka.com/peristiwa/mahasiswa-universitas-brawijaya-temukanalat-penyaring-udara-kotor.html.

[11] Suastiyanti, D. and Hasybi, M. K. (2018). Kekerasan Hasil Pengelasan TIG dan SMAW pada Stainless Steel SS 304 untuk Aplikasi Boiler Shell. Prosiding Seminar Nasional Pakar Tahun 2018 Buku I, pp. 47–52.

[12] Susana, T. (2003). Air Sebagai Sumber Kehidupan. Oseana, vol. 28, issue 3, pp. 17–25.

[13] Purba, J. (2016). Perancangan Boiler Pipa Api Untuk Perebusan Bubur Kedelai pada Industri Tahu Kapastas Uap Jenuh 160 kg/jam. Jurnal Mahasiswa Teknik UPP, Vol. 2, issue 1, pp. 1–8.

[14] Muchta, A. (2018). Prinsip Kerja Generator Listrik (AC dan DC) + Rangkaian. Retrieved from https: //www.autoexpose.org/2018/02/prinsip-kerja-generator-listrik.html?m=1.